Cisco vpn password reset How to reset a user account password using Cisco IOS, the router I used for this was a Cisco ASA5505 however I am sure this guide will be valid for other Cisco vpn password reset’s on Routers / Switches / Firewalls running IOS. Note that these instructions are the same to [...]
Posts Tagged ‘Router’
Cisco vpn password reset how to IOS / ASA
August 26th, 2011 
KJS 
Posted in Cisco, Featured, Networking 
Tags: ASA, Cisco, Cisco vpn password reset, guide, How-To, HowTo, IOS, password reset, Router, user account, VPN 
No Comments »Cisco router port forward NAT & add ACL access-list rules
May 26th, 2011 KJS Setup Cisco Router Port Forward & access-list rule The below has been tested on a Cisco 800 series router however this should work on any Cisco router running IOS, I often have to do this for OWA, Outlook Anywhere or IIS. Before following this guide I would make a backup of your IOS config, I [...]
Posted in Cisco, HowTo, Networking Tags: access-list, ACL, Cisco, IOS, Port Forward, Router 3 Comments »
Cisco factory reset ASA router
April 27th, 2010 KJS Cisco factory reset ASA Cisco factory reset ASA how to guide. I had to do this after I attempted to set up a ASA via ASDM (I should know better right?). Hook up the console cable to your Cisco, and use Putty or hyper terminal to connect to your ASA over serial and follow the [...]
Posted in Cisco Tags: 5500, 5505, Cisco ASA, Cisco Factory Reset ASA, Default, Factory Reset, Factory reset Cisco, IP Addresss, PIX, Router No Comments »Configure a Netgear DG834 with NAT Disabled using a block of public IP addresses from BT
February 24th, 2010 KJS Today I replaced one of those Awful BT 2Wire Modem / Routers which was being used to route a block of 5 Public IP addresses, well in fact it was only being used to route 3 Public IP’s. One to a Cisco ASA providing a VLAN for the VoIP network, One to a SOHO Linksys [...]
