Cisco vpn password reset How to reset a user account password using Cisco IOS, the router I used for this was a Cisco ASA5505 however I am sure this guide will be valid for other Cisco vpn password reset’s on Routers / Switches / Firewalls running IOS. Note that these instructions are the same to [...]
Posts Tagged ‘Cisco’
Cisco vpn password reset how to IOS / ASA
August 26th, 2011 
KJS 
Posted in Cisco, Featured, Networking 
Tags: ASA, Cisco, Cisco vpn password reset, guide, How-To, HowTo, IOS, password reset, Router, user account, VPN 
No Comments »Cisco access list edit
July 5th, 2011 KJS Move up Cisco ACL rules without re adding all access-list rules In the past I have always copied and pasted all Cisco access-list rules into a text editor such as Notepad / TextEdit then edited the ACL rules and re-added them into the Cisco IOS. An alternative way would be to add the rule via [...]
Cisco router port forward NAT & add ACL access-list rules
May 26th, 2011 KJS Setup Cisco Router Port Forward & access-list rule The below has been tested on a Cisco 800 series router however this should work on any Cisco router running IOS, I often have to do this for OWA, Outlook Anywhere or IIS. Before following this guide I would make a backup of your IOS config, I [...]
Posted in Cisco, HowTo, Networking Tags: access-list, ACL, Cisco, IOS, Port Forward, Router 3 Comments »Configure a Netgear DG834 with NAT Disabled using a block of public IP addresses from BT
February 24th, 2010 KJS Today I replaced one of those Awful BT 2Wire Modem / Routers which was being used to route a block of 5 Public IP addresses, well in fact it was only being used to route 3 Public IP’s. One to a Cisco ASA providing a VLAN for the VoIP network, One to a SOHO Linksys [...]
